Test Preparation
1. Allow all kit components to equilibrate to room temperature (15-30°C) prior to testing for 30 minutes,if previously stored in a cool place.
2. Do not eat, drink, smoke, brush teeth, or chew gum for 30 minutes before collecting saliva.
Specimen Collection & Extractio
1. Spit the expectorated saliva into the collection funnel gently as much as possible close to 1mL.
2. Unscrew the collection funnel gently to allow the saliva flow into the collection tube completely.
3. Screw the nozzle onto the collection tube.
4. Turn upside down the collection tube slightly for 5 seconds, so that the diluent can mix with the saliva sample evenly.
5. Leave the collection tube stand at room temperature for 5 minutes.
6. Remove the nozzle cap.
Reaction with Test Cartridge
7.Remove a test cartridge from the sealed pouch by tearing at the notch and place it on a level surface.
Drip vertically 2~3 drops of liquid at 2~3 second intervals into the specimen well (S) on the test cartridge by squeezing the tube. Do not handle or move the test cartridge until the test is complete and ready for reading.
8. Start timer. Read result within 15 ~20 minutes of adding the liquid . The test result is invalid after 20 minutes.
————————————————————————————————————————————————————
测试准备
1. 如果之前存放在阴凉处，则在测试 30 分钟之前，让所有套件组件平衡至室温 (15-30°C)。
2. 采集唾液前 30 分钟内请勿进食、饮水、吸烟、刷牙或嚼口香糖。
样本采集和提取
1.将咳出的唾液轻轻吐入收集漏斗中，尽可能接近1mL。
2. 轻轻旋开收集漏斗，让唾液完全流入收集管。
3. 将喷嘴拧到收集管上。
4. 轻轻翻转采集管5秒，使稀释液与唾液样本混合均匀。
5. 将收集管在室温下静置 5 分钟。
6. 拆下喷嘴盖。
与测试盒的反应
7. 撕开缺口，从密封袋中取出测试盒，并将其放置在水平表面上。
挤压管子，以 2~3 秒的间隔垂直滴入 2~3 滴液体到测试盒上的样品孔 (S) 中。在测试完成并准备好读取之前，请勿处理或移动测试盒。
8. 启动定时器。添加液体后15~20分钟内读取结果。 20分钟后测试结果无效。
- Able to conduct 3 tests at once ( Covid-19, Influenza A & B ) 能够一次进行 3 项测试（Covid-19、甲型和乙型流感）
- Results in 15 mins 15 分钟内出结果
- Sensitivity: 94.3% 灵敏度：94.3%
- Specificity: 100% 特异性：100%
- MDA approved. MDA 批准
- Certified by ISO13485. 通过ISO13485认证
