Note:
This gauge is with stepper motor, so it is not a problem if the needle not be zero, and the needle will be zero after you connect the all wire and power on it.
Please note that the meter will not work if only the black and red wires are connected. Be sure to connect the white or orange wire!
Product Description：
Condition:100% Newwith orginal Dynoracing packaging.
With high speed stepper motor ,give you a quick response.
Two installation methods according to your preference.
Numbers and pointer clearly show
lighting on the dial for easy reading in the darkness.
High sensitivity and easy operation.
Note:Easy Installation
Professional installation is Highly Recommended.
Specifications:
Color: Black Face / White Light & Amber Light
Power:DC 12V Professional.
Diameter:2.5"/60mm.
Unit: Kpa
Measurement range: 0~2 (100kpa)
Universal fit for: 12Volt Cars
One Boost gauge With Two backlight(Amber and White light)
Package Includes:
1*Turbo Gauge
1*Gauge Standand mounting accessories
1*Screw knob
1*Sensor
1*Tubing + T piece + Filter
1*Cables
1*Installation Manual
1*Retail Dynoracing Box
Question and solution（Please connect the boost sensor for subsequent setup）:
1:How to cancel the buzzing sound?
If you want to cancel the buzzing sound, just restart the power supply and hold the button until the buzzing sound disappears, then release the button. Vice versa.
2:How to set the PEAK Value
After completing the Self-checking, press the button and release, the PEAK lights up (blue light). Then hold the button again for 3 seconds, when the PEAK light flashes, release the button, PEAK value is cleared, the pointer will returns to zero after about 3 seconds.
3:How to set alarm points and cylinder:
After self-examination, hold the button for 5 seconds, the pointer lights flicker, loosen, and then press the button to set the alarm point (Press the button continuously and fleetly for fine setting, press and hold the button continuously for quick setting). After about 5 seconds, the pointer automatically returns to zero, you can then set the next Step.
After self-test or after the pointer returns to zero, hold the button for 10 seconds, the pointer lights flicker, loosen, and then press the button to set the cylinder, loosen, after 5 seconds, the pointer automatically returns to zero, you can set the next step.
When the meter reaches the alarm value, the lights will flicker continuously.
