Note:
This gauge is with stepper motor, so it is not a problem if the needle not be zero, and the needle will be zero after you connect the all wire and power on it.
Please note that the meter will not work if only the black and red wires are connected. Be sure to connect the white or orange wire!
Features:
Gauge is 60mm (will fit the majority of aftermarket gauge holders or can be used with the included stand)
Can be wired up to light up WHITE or AMBER.(Warning RED)
Comes with everything required for install as pictured (including sensor)
This WaterTempgauge has a range of 50- 150 degree celsius
Power: DC 12V Professional.
Adjustable warning setting (can be set anywhere between 60 - 150).
Peak display - allows you to show your highest reading with a push of a button.
When initially powered on, the gauge displays an opening ceremony which calibrates the gauge to ensure accurate reading.
Fit for most 12Volt Car
Package Includes:
-Water Temp Gauge
-Gauge Stand
-Screw knob
-Sensor
-Cabling
-Installation Manual
-Retail Box
Note: Easy Installation With Users Manual In English, Professional installation is Highly Recommended.
Gauge Function Settings:
-
Buzzing Sound
If you want to cancel the buzzing sound, just restart the power supply and hold the button until the buzzing sound disappears, then release the button. Vice versa. (Need to operate before the meter self-check is completed)
-
Clear the PEAK Value
After completing the Self-check, press the button and release, the PEAK lights up (blue light). Then hold the button again for 3 seconds, when the PEAK light flashes, release the button, PEAK value is cleared, the pointer will returns to zero after about 3 seconds.
-
Set Alarm Points and Cylinder
After self-check, hold the button for 5 seconds, the pointer lights flicker, loosen, and then press the button to set the alarm point (Press the button continuously and fleetly for fine setting, press and hold the button continuously for quick setting). After about 5 seconds, the pointer automatically returns to zero, you can then set the next Step.
After self-check or after the pointer returns to zero, hold the button for 10 seconds, the pointer lights flicker, loosen, and then press the button to set the cylinder, loosen, after 5 seconds, the pointer automatically returns to zero, you can set the next step.
When the meter reaches the alarm value, the lights will flicker continuously.
