Note:
This gauge is with stepper motor, so it is not a problem if the needle not be zero, and the needle will be zero after you connect the all wire and power on it.
Please note that the meter will not work if only the black and red wires are connected. Be sure to connect the white or orange wire!
Package Includes:
1*RPM Gauge
1*Gauge Stand with mounting accessories
2*Cables
1*Screw knob
1*Installation Manual
1*Retail Dynoracing Box
Features:
Condition:100% New with orginal Dynoracing packaging.
With high speed stepper motor ,give you a quick response.
Two installation methods according to your preference.
Can be wired up to light up WHITE or AMBER.(Warning RED)
Comes with everything required for install as pictured
This RPM gauge has a range of 0 - 10,000 RPM
Gauge takes RPM reading from your ECU.
Works on 4/6/8 Cylinder engine and 12VOLT Gasoline car
Adjustable warning setting
Peak display - allows you to show your highest reading with a push of a button.
When initially powered on, the gauge displays an opening ceremony which calibrates the gauge to ensure accurate reading
Gauge Function Settings:
-
Buzzing Sound
If you want to cancel the buzzing sound, just restart the power supply and hold the button until the buzzing sound disappears, then release the button. Vice versa. (Need to operate before the meter self-check is completed)
-
Clear the PEAK Value
After completing the Self-check, press the button and release, the PEAK lights up (blue light). Then hold the button again for 3 seconds, when the PEAK light flashes, release the button, PEAK value is cleared, the pointer will returns to zero after about 3 seconds.
-
Set Alarm Points and Cylinder
After self-check, hold the button for 5 seconds, the pointer lights flicker, loosen, and then press the button to set the alarm point (Press the button continuously and fleetly for fine setting, press and hold the button continuously for quick setting). After about 5 seconds, the pointer automatically returns to zero, you can then set the next Step.
After self-check or after the pointer returns to zero, hold the button for 10 seconds, the pointer lights flicker, loosen, and then press the button to set the cylinder, loosen, after 5 seconds, the pointer automatically returns to zero, you can set the next step.
When the meter reaches the alarm value, the lights will flicker continuously.
