PACKAGE 3 IN 1
PRO-LINE ENIGNG FLUSH 500MLMOS2 OIL ADDITIVE 300MLINJECTION CLEANER 300ML
PACKAGE 3 IN 1
**** PRO-LINE ENIGNG FLUSH 500ML
Cleans the engine from the inside and removes deposits from oil holes, bearings, the piston ring area, etc. Reduces engine noise and oil consumption, improves compression and increases operating reliability of the vehicle. Allows the fresh oil to realize its full potential following an oil change. Suitable for all gasoline and diesel engines with and without a particulate filter (DPF/GPF). Ensures the perfect hydraulic function of oil-controlled systems such as VVT, VANOS and similar. Can be safely used in vehicles with toothed belt running in oil. 500 ml are sufficient for up to 5 l of oil. Tested for use with catalytic converters and turbochargers.
Application
500 ml is sufficient for up to 5 l of oil. Add to motor oil at operating temperature before an oil change. After adding the product, allow the engine to idle for 10 – 15 minutes depending on the degree of contamination. Then change the oil and the filter. Compatible with all commercially available motor oils.
**** MOS2 OIL ADDITIVE 300ML
MoS2 Anti-Friction Engine Treatment ensures immediate friction and wear reduction, adds an extremely protective and pressure-resistant boundary layer with low friction and lubricates during cold starts to prevent damage from lack of oil. Contributes to lower fuel consumption, longer engine life and less noise. Specifically designed for older engine designs with or without a turbocharger.
For all 4-stroke gasoline and diesel engines, with or without turbochargers. Miscible with most commercially available motor oils. Safe for use with catalytic converters and particulate filters (GPF/DPF). Not suitable for use with wet clutches! Contents (300 ml) is sufficient for 3–6 Liters (0.8 gal. to 1.6 gal.) motor oil. Shake well before use.
Application
Contents (300 ml) is sufficient for 3–6 Liters (0.8 gal. to 1.6 gal.) motor oil. Ideal mixing ratio is at around 5% (50 mL per liter of oil). The product is self mixing and can be added at any time. Shake well before use.
**** INJECTION CLEANER 300ML
Removes deposits on injection valves, intake valves, spark plugs and in the combustion chamber and prevents new deposits from forming. Eliminates starting problems and rough engine running. Maintains all components of the gasoline injection system. Protects the entire fuel system against corrosion. Improves throttle response and compression. Optimizes the emission test values and the performance of the engine. Clean engines use less fuel and reduce the pollutant emissions. For all gasoline engines, gasolines and operating conditions. Preventive or remedial. To be added directly into the fuel tank. 300 ml sufficient for up to 70 l of fuel. Effect remains for up to 2,000 km. Tested for turbochargers and catalytic converters.
Application
300 ml is sufficient for 70 l of fuel. Has a long-term effect of 2,000 km. Can be mixed with fuel at any time since mixing takes place automatically. Repeat treatment if problems
