Note:

This gauge is with stepper motor, so it is not a problem if the needle not be zero, and the needle will be zero after you connect the all wire and power on it.

Please note that the meter will not work if only the black and red wires are connected. Be sure to connect the white or orange wire!

Turbo Boost Gauge:

Condition:100% New.

Power:DC 12V Professional.

Diameter:2.5"/60mm.

Note:Easy Installation With Users Manual In English,Professional installation is Highly Recommended.

Unit: BAR

6 Months Warranty

Universal fit for: 12 Volt cars.

Turbo Boost Controller Kit:

Boost Control From: 1~30 PSICapacity

Material:CNC Machined Aluminum Body

Dimension: L: 3.2 W: 0.75 H: 0.75

Hose, clamp and all necessary hardware for complete installation

Professional installation in highly recommended (No instruction included)

Package include:

1 *Boost Gauge 3BAR

1* Boost Sensor

1* Vacuum pipe

1* T Joint

2 *Screw

1 * Cable

1* Gauge Holder

1*Screw knob

1 * Manual Boost Controller

1 * Diverter Tee

2 * Billet Mounting Bracket

Gauge Function Settings:

1. Buzzing Sound

If you want to cancel the buzzing sound, just restart the power supply and hold the button until the buzzing sound disappears, then release the button. Vice versa. (Need to operate before the meter self-check is completed)

2. Clear the PEAK Value

After completing the Self-check, press the button and release, the PEAK lights up (blue light). Then hold the button again for 3 seconds, when the PEAK light flashes, release the button, PEAK value is cleared, the pointer will returns to zero after about 3 seconds.

3. Set Alarm Points and Cylinder

After self-check, hold the button for 5 seconds, the pointer lights flicker, loosen, and then press the button to set the alarm point (Press the button continuously and fleetly for fine setting, press and hold the button continuously for quick setting). After about 5 seconds, the pointer automatically returns to zero, you can then set the next Step.

After self-check or after the pointer returns to zero, hold the button for 10 seconds, the pointer lights flicker, loosen, and then press the button to set the cylinder, loosen, after 5 seconds, the pointer automatically returns to zero, you can set the next step.

When the meter reaches the alarm value, the lights will flicker continuously.