Features:1.12V-16.8V input, wide power adaptability, optional car emergency starting power supply, car, aircraft model high magnification pack, etc. (must have good performance, at least can start the car)2.Built-in imported MOS tube, built-in imported low-resistance high-power MOS tube can withstand 500A current and low heat (conventional spot welding current is about 80-150A)3.Stepless adjustment beyond 99 gears is applicable to common 0.1mm nickel plate. If 0.2mm overlap welding is required4.Power adjustment knob, reducing complexity to simplicity, low counterclockwise power, high clockwise power, stepless adjustment5.Trigger button, output a high-energy pulse every time the welding needle is pressed, the welding efficiency is at will, and the output pulse indicator light is provided (yellow/green with different light colors in batches)6.This product is very suitable for electronics enthusiasts to assemble or use DIY pack. With the design concept of reducing complexity to simplicity, it puts aside the meaningless ingenious functions and focuses on convenience and practicality.
Parameters:Body size: 25mm * 170mmWire length: 350mmWire specification: 12AWG silicone wirePower interface: copper ear/EC5 (package optional)Operating voltage: 12V-16.8VSpot welding current: 80A-15OAPower module: imported 550A MOS tubeShell material: high-temperature resistant nylonSpot welding material: 0.1mm nickel-plated stripSpecification of welding pin: 3MM * 1.5MM * 40MM professional aluminum oxide copper welding pinOther remarks: copper needle is standard and can be replaced
The supporting nickel sheet is 6 mm wide and 0.1 mm thick nickel-plated steel strip, each roll is about 6 meters long;According to the package, the copper ear interface is suitable for the or high-magnification aviation model lithium pack, and the EC5 interface is suitable for the automobile emergency starting power supplyThis product does not contain batteries. Customers need to match lead-acid batteries with good performance in the voltage range of 12V-16.8V or high power pack, or emergency starting power supply for automobiles. (The performance of the needs the ability to start the car, because the instantaneous current of spot welding is up to 150A). The above batteries cannot be replaced by transformers or power adaptersIt is recommended to weld the nickel-plated steel strip within 0.1mm, and the effect of 0.2mm can also be obtained by overlaying two times of welding. Pure nickel or copper and aluminum shall not be welded.Key points for use:1. The should be strong enough, the interface should be firm, the wires should not be extended at will, and the spot welding should be adjusted from low power up slowly enough to avoid excessive current affecting MOS tube performance. Do not connect the input terminal with the electrode reversely, and do not use it beyond the specified voltage range2. It is recommended to use 12V 20AH-60AH lead-acid with good performance, or 3 or 4 power packs with high magnification, or automobile emergency starting power supply as the power input (It must have good performance, at least the level of starting the car, and the voltage range is 12V-16.8V)
Package include:1 pair of X integrated welding pen body (including silica gel power cable 12AWG, about 35CM)1 roll of X nickel sheet (about 6m)