Malaysia spot!
attention:
- Please purchase enough rolls at a time to ensure that they are from the same batch to avoid color difference.
- The wallpaper you receive may have some wrinkles on the top or both ends, but it will not affect the glue care of the surface.
Product name: Frosted self-adhesive glass film
Pasting method: oily glue adsorption, no glue needed
Material: high quality PVC
UV protection: more than 80%
Uses: decoration, heat insulation, privacy protection, etc.
Scope of application: any smooth glass surface
Specification:
Ordinary pure frosted, thickened pure frosted
The difference between normal and thickened:
Normal thickness: Approximately 0.10mm
Thickened thickness: about 0.14mm
size:
-100cm*45cm (length*width)
-100cm*60cm (length*width)
-100cm*90cm (length*width)
-100cm*120cm (length*width)
-300cm*45cm (length*width)
-300cm*60cm (length*width)
-300cm*90cm (length*width)
-300cm*120cm (length*width)
Instructions:
1. Measure the size of the glass, when cutting the film, leave 2 to 3 cm on each side.
2. Clean the glass.
3. Use a watering can or self-made mineral water bottle to pierce the hole, spray more water on the glass, the more the better. (to ensure that the film loses its viscosity)
4. Tear one end of the film and fix it on the glass, and then tear off the low paper while sticking it. Spray water on the glued surface of the film to ensure that the film loses its viscosity temporarily.
5. Because there is water, you can adjust the position of the glass film at will and use a scraper to drive out the water and bubbles. If there are no bubbles, only the water is driven out.
6. Use a knife to cut off the extra side that was just left out, and then dry it with a rag to complete it.
