Malaysia Leading Online Shopping Marketplace

  • Jual Dengan Kami
  • Ikut Kami Di
  • Notifikasi
    Notifikasi Baharu
  • Help
  • Daftar
  • Log Masuk

Sila Log Masuk untuk melihat produk.

BetaFPV F4 1S/2S 12A AIO Brushless Flight Controller
No Rating Yet
0 Dijual

/ Per Produk

Penghantaran

Penghantaran Dari
Mainland China
Anggaran Penghantaran
Nov 22, 2024 - Dec 13, 2024

Warna

Sila pilih variasi produk terlebih dahulu

Kuantiti

100 Unit lagi
Jumlah
RM 296.4
Gambaran Kedai
MAOLI Good Goods
18 minutes ago
Produk 40268
Pengikut 144
Penilaian 4.7
Sertai Within a Year
Kadar Pembatalan 0%
Spesifikasi Produk
Category
: Electronic Devices  >  Camera  >  Drones & Aerial Imaging
Brand
: BetaFPV
Model
: Not Specified
SKU
: X2ZV8006
Dimension (Length x Width x Height)
: 10.00 x 15.00 x 20.00
Weight(kg)
: 0.6
Manufacturing Country
: Not Specified
Warranty Type
: No Warranty
Warranty Value
: -
Warranty Description
: -
Hantar Dari
: Mainland China
Deskripsi Produk
What is the update of the ELRS 2.4G V2.0 board?
Support both 1S and 2S battery now. Only 1S supported on V1.0.
Use SPI ExpressLRS 2.4 receiver with Betaflight firmware.
Modify the shape of the board to support 85mm whoop frame. Only toothpick frame supported on V1.0.
Use the lighter and smaller SH connector instead of USB Type-C.
F4 1S 12A AIO Flight Controller - A 1S 12A FC for building lightweight 3" toothpick drones like HX115 SE Toothpick Drone and HX115 LR Toothpick Drone. If you want to try a bigger FPV drone than 65mm/75mm on 1S power, and still want smooth and powerful flying actions, this FC that integrates 1S 12A ESC is definitely your best choice.

*** Now the default firmware for F4 1S 12A AIO Brushless Flight Controller is updated to Betaflight V4.3.0 Official version, which supports ELRS V2.0. Please check the below link to download the firmware.




Bullet Point
F4 1S 12A AIO Flight Controller is the best choice for building ultra-lightweight 3" toothpick drones like HX115 SE FPV Quad.
Most of the 1S flight controllers on the market come with 5A ESC by now, but this FC especially integrates 1S 12A ESC, it can provide more sufficient power for 3" toothpick drones.
Built-in current meter, 2 programmable RGB LEDs, and SPI Frsky receiver. At the same time, all the pads are left for the external receivers with UART1 and UART2, for buzzers, etc.
Whoop mounting hole pattern, be compatible with most 1S 3" frames. Large pads are reserved for solder motor cables, this design will make solder easier.

Specification of FC
Item: F4 1S 12A AIO FC
Weight: 4.74 g (without power cable and BT2.0 connector)
CPU: STM32F411CEU6 (100MHZ )
Six-Axis: MPU6000 (SPI connection)
Firmware version: betaflight_4.2.0_STM32F411
OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
Receiver: Integrated SPI Frsky Receiver / Futaba Receiver / ELRS Receiver
Motor Pin Connecter: 1.25mm Header Pins
Mounting Hole Size: 26mm x 26mm (suitable for whoop pattern mounting hole)
USB Port: Type-C (V1.0 board), SH1.0 4-Pin (V2.0 board)

Specification of 1S 12A ESC
Built-in ESC with 12A continuous and peak 25A current
Input voltage: 1S Lipo (V1.0 board), 1S-2S (V2.0 board)
ESC firmware: Z_H_30_REV16_7.HEX
Signal support: D-shot150, D- shot300, D-shot600, Oneshot125, Multishot, PWM

This new BLHeli_S firmware (named Z_H_30_REV16_7.HEX) is supported by BLHeli Configurator, BLHeliSuite, and Bluejay Configurator for setup.

For download and flash, update to the newest BLHeliSuite-16714902a to support this ESC firmware online. For BLHeli Configurator or Bluejay Configurator, you need to load it local. The ESC firmware is available for download here.

Package
1 * F4 1S 12A AIO FC
4 * Anti-vibration rubber dampers
4 * M2 x 10mm screws
4 * M2 x 10mm screws
8 * M2 screw nut
1 * BETAFPV dipole T antenna (2.4G/46mm, only for ELRS RX version board)
8 * PH-1.25 connector for motor (not soldered, only for ELRS RX version board)
Penilaian produk
- / 5.0
Copy Link
Copy Link
Copy
Copied to Clipboard!
  • 0 Troli Membeli-belah
  • Wishlist
  • Pusat Kupon
  • Informasi
  • Chat
  • Log Masuk / Daftar
  • What's In The Box
  • Kongsi
  • Kembali
  • Kembali Ke Atas
    • ©2024 PG Mall Sdn. Bhd. 200801035285 (836625-K). All Rights Reserved.